Durham University
Programme and Module Handbook

Undergraduate Programme and Module Handbook 2014-2015 (archived)

Module ENGI2141: Mechanics and Materials

Department: Engineering

ENGI2141: Mechanics and Materials

Type Tied Level 2 Credits 20 Availability Available in 2014/15 Module Cap None. Location Durham
Tied to H100
Tied to H103

Prerequisites

  • As specified in programme regulations.

Corequisites

  • As specified in programme regulations.

Excluded Combination of Modules

  • As specified in programme regulations.

Aims

  • This module is designed solely for students studying School of Engineering and Computing Sciences MEng and BEng degree programmes.
  • The module builds knowledge in the mechanics of dynamics and vibration, stress analysis of structures and sections, metallurgy and materials properties.
  • The module provides an introduction to finite element methods.

Content

  • Mechanics: Axisymmetric stress analysis problems, shear stresses due to bending, finite element analysis of simple beams and trusses, vibration of single degree of freedom and 2 degree of freedom systems, introduction to acoustics.
  • Materials: Atomic structure and Electronic materials, Metallurgy, Particulate materials.

Learning Outcomes

Subject-specific Knowledge:
  • At the end of the year the student should be able demonstrate knowledge and understanding of the theory and application of engineering mechanics and materials.
Subject-specific Skills:
  • Selection and application of appropriate analysis techniques.
  • Use of matrix algebra for problems in structural systems under static and dynamic loads.
  • Observation and recording of experimental data.
  • Preparation of technical reports.
  • Technical presentations.
  • The competent and safe use of laboratory equipment.
  • Understanding of risk assessment and COSHH.
Key Skills:
  • Numerical skills.
  • Analytical skills.
  • Time and resource management.

Modes of Teaching, Learning and Assessment and how these contribute to the learning outcomes of the module

  • The courses in Mechanics and Materials are covered in lectures which are supported by seminars and by weekly problem sheets leading to the required problem solving capability.
  • The topics covered in this module are analytical by nature and are assessed most effectively by timed, written examination which enables each student to demonstrate an ability to analyse and solve new problems.
  • A laboratory programme provides formative, hands-on experience in the subject area of mechanics and materials.
  • Students are able to make use of staff 'Tutorial Hours' to discuss any aspect of the module with teaching staff on a one-to-one basis. These are sign up sessions available for up to one hour per week.

Teaching Methods and Learning Hours

Activity Number Frequency Duration Total/Hours
Mechanics of Dynamic Systems lectures 21 1 per week 1 Hour 21
Mechanics of Static Systems lectures 21 1 per week 1 Hour 21
Materials lectures 21 1 per week 1 Hour 21
Tutorial Hours as required weekly sign up sessions up to 1 hour 8
Seminars 3 1 Hour 3
Mechanics and materials laboratories 3 1st and 2nd term 3 Hours 9 ■
Problem classes 4 1 Hour 4 ■
Preparation and Reading 113
Total 200

Summative Assessment

Component: Examination Component Weighting: 100%
Element Length / duration Element Weighting Resit Opportunity
Mechanics 2 [Static Systems and Dynamic Systems] 2 hours 70% yes
Materials 2 [Materials] 1 hour 10 minutes 30% yes

Formative Assessment:

Laboratories.

■ Attendance at all activities marked with this symbol will be monitored. Students who fail to attend these activities, or to complete the summative or formative assessment specified above, will be subject to the procedures defined in the University's General Regulation V, and may be required to leave the University